TXS0108E-Q1 - 8-Bit Bi-directional, Level-Shifting, Voltage Translator for Open-Drain and Push-Pull Applications

This 8-bit non-inverting translator uses two separate configurable power-supply rails. The A port tracks the V_CCA pin supply voltage. The V_CCA pin accepts any supply voltage between 1.4 V and 3.6 V. The B port tracks the V_CCB pin supply voltage. The V_CCB pin accepts any supply voltage between 1.65 V and 5.5 V. Two input supply pins allows for low Voltage bidirectional translation between any of the 1.5 V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.

When the output-enable (OE) input is low, all outputs are placed in the high-impedance (Hi-Z) state.

To ensure the Hi-Z state during power-up or power-down periods, tie OE to GND through a pull-down resistor. The minimum value of the resistor is determined by the current-sourcing capability of the driver.

• AEC-Q100 Qualified for Automotive Applications
  • Device Temperature Grade 1: –40°C to 125°C
  • Device HBM ESD Classification Level 2
  • Device CDM ESD Classification Level C6
• No Direction-Control Signal Needed
• Maximum Data Rates
  • 110 Mbps (Push Pull)
  • 1.2 Mbps (Open Drain)
• 1.4 V to 3.6 V on A Port and 1.65 V to 5.5 V on B
  Port (V_CCA ≤ V_CCB)
• No Power-Supply Sequencing Required – Either
  V_CCA or V_CCB Can Be Ramped First
• Latch-Up Performance Exceeds 100 mA Per
  JESD 78, Class II
• ESD Protection Exceeds JESD 22 (A Port)
  • 2000 V Human Body Model (A114-B)
  • 1000 V Charged-Device Model (C101)
• IEC 61000-4-2 ESD (B Port)
  • ±8 kV Contact Discharge
  • ±6 kV Air-Gap Discharge