UCC20520 - 4-A, 6-A, 5.7-kVRMS Isolated Dual-Channel Gate Driver with Single Input

The UCC20520 is an isolated single input, dual-channel gate driver with 4-A source and 6-A sink peak current. It is designed to drive power MOSFETs, IGBTs, and SiC MOSFETs up to 5-MHz with best-in-class propagation delay and pulse-width distortion.

The input side is isolated from the two output drivers by a 5.7-kV_RMS reinforced isolation barrier, with a minimum of 100-V/ns common-mode transient immunity (CMTI). Internal functional isolation between the two secondary-side drivers allows a working voltage of up to 1500-V_DC.

This driver can be used for half-bridge driver with programmable dead time (DT). A disable pin shuts down both outputs simultaneously when it is set high, and allows normal operation when left open or grounded. As a fail-safe measure, primary-side logic failures force both outputs low.

The device accepts VDD supply voltages up to 25-V. A wide input VCCI range from 3-V to 18-V makes the driver suitable for interfacing with both analog and digital controllers. All the supply voltage pins have under voltage lock-out (UVLO) protection.

With all these advanced features, the UCC20520 enables high efficiency, high power density, and robustness in a wide variety of power applications.

• Single Input, Dual Output
• Operating Temperature Range –40 to +125°C
• Switching Parameters:
  • 19-ns Typical Propagation Delay
  • 10-ns Minimum Pulse Width
  • 5-ns Maximum Delay Matching
  • 5-ns Maximum Pulse-Width Distortion
• Common-Mode Transient Immunity (CMTI) Greater than 100-V/ns
• Surge Immunity up to 12.8-kV
• Isolation Barrier Life >40 Years
• 4-A Peak Source, 6-A Peak Sink Output
• TTL and CMOS Compatible Inputs
• 3-V to 18-V Input VCCI Range to Interface with Both Digital and Analog Controllers
• Up to 25-V VDD Output Drive Supply
• Programmable Dead Time
• Rejects Input Pulses and Noise Transients Shorter than 5-ns
• Fast Disable for Power Sequencing
• Industry Standard Wide Body SOIC-16 (DW) Package
• Safety-Related and Regulatory Approvals:
  • 8000-V_PK Isolation per DIN V VDE V 0884-10 (VDE V0884-10):2006-12
  • 5700-V_RMS Isolation for 1 Minute per UL 1577
  • CSA Component Acceptance Notice 5A, IEC 60950-1 and IEC 60601-1 End Equipment Standards (Planned)
  • CQC Certification per GB4943.1-2011